MSA Evolution 6000 Manual de Serviço descarregar pdf (Página 30)

EVOLUTION 6000 Thermal Imaging Camera

Use

MSA

3.10 Battery Installation

The EVOLUTION 6000 series cameras run on a single lithium Ion battery pack.

Replacement batteries must have the same power and layout as those delivered by MSA with the

camera. Unsuitable batteries can lead to a system failure.

NOTE: To remove battery, reverse the above Battery Installation procedure.

WARNING

Risk of injury!

Never replace the batteries in a hazardous location or an explosive atmosphere. There is a risk

of explosion since the batteries can spark when being changed!

(1) Place the camera on a clean, non-abrasive surface.

(2) Open the battery compartment by pulling down on

the battery latch and swinging the battery compart-

ment door forward.

(3) Place the battery inside the battery compartment

with the battery logo and arrow pointing toward the

top of the camera. The battery compartment is de-

signed to prevent incorrect battery insertion.

(4) Gently push the battery into place.

(5) Close and latch the battery compartment.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 45 46

Sem comentários

MSA Evolution 6000 Manual de Serviço Página 30